Icmp unreachable rate-limit 1 burst-size 1
ASA 5505 DPD EASYVPN PASSWORD
I appreciate your assistance.Įnable password KT0sz5W1kIw2GQaU encryptedĪccess-list inside_access_in extended permit ip any anyĪccess-list outside_access_in extended permit tcp any any eq 5001Īccess-list outside_access_in extended permit tcp any any eq 1554Īccess-list outside_access_in extended permit tcp any any eq 1553Īccess-list outside_access_in extended permit udp any any eq sip If configs would help, I'm happy to post them. I can't believe that I can get this to run behind freely available firewalls, but when I put all Cisco equipment into the mix, it doesn't work. So I'm getting I'm missing a setting somewhere on the VPN ASA, however I am doing network extension with the ASA, not just a client.
ASA 5505 DPD EASYVPN SOFTWARE
If I get rid of the transparent tunneling on my software client, I get the same behavior as I do with the VPN ASA. However when I configure UDP on the 3030, it uses the port for UDP. When I do that, it gray's out the port option, as it appears that's only used for TCP. What's funny is that I had to make a change on the software VPN client to tell it to use UDP. I don't see them for my software VPN client connection. When I'm trying to access anything across the tunnel, on the firewall ASA, I see alot of these messages:ġ9:20:31 305006 regular translationeation failed for protocol 50 src inside: 10.5.1.2 dst outside: Checking the tunnel status on the 3030 side shows the TX bytes incrementing, but no RX bytes. The tunnels come up, but I can't pass any traffic. I've walked through the config for EasyVPN again and am still in the same boat. I've upgraded the ASA image to 7.2.3 and the ASDM image 5.2.3. Ok, I came home, and did a complete factory reset on the VPN ASA.
0 kommentar(er)
